National Instruments CMS-9068, Поддержание работоспособности оборудования

Страница: 19 / 23

POWER LED
The POWER LED is lit while the cRIO-9068 is powered on. This LED indicates that the
power supply connected to the controller is adequate.
STATUS LED
The STATUS LED is off during normal operation. After the device powers on, the cRIO-9068
indicates specific error conditions by flashing the STATUS LED a certain number of times
every few seconds. If you observe this behavior after the device powers on, contact NI
support.
USER1 LED
The USER1 LED can display the indications described in the following table:
Table 4. USER1 LED Indications
Indication Description
Flashing rapidly Indicates an error condition. Open the InsightCM web application to the
Devices tab on the Dashboard page to see the device status.
Flashing steadily Indicates normal operation.
Solid
Indicates that USB operations are in progress, such as reading or writing
the connection information file. You can safely remove the USB drive
when this LED resumes blinking steadily.
Note
This device polls USB drives every 15 seconds, so you
might need to wait up to 15 seconds after a USB operation
begins for the LED to light.
USER FPGA1 LED
NI Monitoring Devices do not use the USER FPGA1 LED.
18 | ni.com | Maintaining NI CMS-9068, MMS-9068, and EMSA-9068 Hardware for an NI InsightCM Device