1.
Fasten the panel mounting plate to the chassis using a number 2 Phillips screwdriver and
M4 × 22 screws. National Instruments provides these screws with the panel mounting kit.
You must use these screws because they are the correct depth and thread for the panel
mounting plate. Tighten the screws to a maximum torque of 1.3 N · m (11.5 lb · in.).
2.
Fasten the panel mounting plate to the surface using the screwdriver and screws that are
appropriate for the surface. The maximum screw size is M5 or number 10.
Caution
Ensure that the chassis does not contain any I/O modules before you
remove it.
Mounting the Chassis on a DIN Rail
Complete the following steps to use the NI 9915 DIN rail mounting kit (part number
779018-01) to mount the chassis on a standard 35-mm DIN rail.
1.
Fasten the DIN rail clip to the chassis using a number 2 Phillips screwdriver and M4 × 22
screws, as shown in the following figure. National Instruments provides these screws
with the DIN rail mounting kit. Tighten the screws to a maximum torque of
1.3 N · m (11.5 lb · in.).
Figure 6.
Installing the DIN Rail CLIP on the cRIO-9114
2.
Insert one edge of the DIN rail into the deeper opening of the DIN rail clip, as shown in
the following figure.
Maintaining NI CMS-9024 Hardware for an NI InsightCM System
|
© National Instruments
|
7