National Instruments CA-1000, Руководство по установке

Страница: 13 / 21

CA-1000 12 ni.com
Figure 7. Installing the 68M-50F MIO Bulkhead Cable
I/O Panelettes
Use the user-configurable I/O panelettes to specify the type and
combinations of I/O connectivity for your application. The interchangeable
I/O panelettes have standard prewired I/O connectors. You can install
I/O panelettes on the front and/or rear of the CA-1000 enclosure.
You can install up to 18 single-width I/O panelettes, nine in the front and
nine in the rear, in the CA-1000 enclosure. You can mix all types of
I/O panelettes to produce custom I/O combinations.
Note The strain-relief and 9-pin D-sub I/O panelettes require two panelette spaces.
The dual 9-pin D-sub I/O panelette requires three panelette spaces.
Each thermocouple and BNC I/O panelette accommodates two connectors.
Use the strain-relief I/O panelettes to connect large numbers of wires
directly to your internal accessory. You can machine the blank
I/O panelettes to make custom I/O panelettes to suit your application.
Use the preconfigured I/O panelettes to quickly connect and disconnect
standard connectors.
1 4-40
×
3/16 in. Screws
2 M2.5 Jacksocket Screws
3 68-Pin Filler Panel
4 68M-50F MIO Bulkhead Cable Adapter
5 Blank Filler Panel
6 R50M-50F Ribbon Cable
a. Filler Panel and Adapter Assembly b. Adapter and Ribbon Cable Assembly
1
2
3
4
5
1
6