•
Riser card (x1)
•
Male-to-female M2.5 standoffs (10 mm hex length, 6 mm thread length) (x2)
•
Male-to-female M2.5 standoffs (12.5 mm hex length, 3.5 mm thread length) (x2)
•
M2.5x8 screws (x2)
•
M2.5x6 screws (x2)
Complete the following steps to install one to four AIO-3681/3682 modules, depending on
your chosen hardware configuration.
1.
Install a riser card into the ATCA-3671 motherboard mating connector. Secure with two
male-to-female M2.5 standoffs (10 mm hex length, 6 mm thread length), as shown in the
following figure.
Figure 4. Installing Riser Card(s)
FPGA Module for A
TCA
ATCA
-3671
1
3
2
1. ATCA-3671 Module
2. Riser Cards
3. Male-to-Female M2.5 Standoff (10 mm Hex Length, 6 mm Thread Length)
8
|
ni.com
|
ATCA-3671 Getting Started Guide