Getting Started with AKD EtherCAT Drives and NI SoftMotion
|
© National Instruments
|
5
Use the LabVIEW Project to configure all your axis settings and test your configuration. When
your hardware configuration is complete, you use NI SoftMotion to create move profiles. Refer
to the
NI SoftMotion Module Help
, available by selecting
Help»LabVIEW Help
, for
information about using the NI SoftMotion Module to create motion applications. Use the
NI Example Finder to browse and search installed NI SoftMotion Module examples. Select
Help»Find Examples
to launch the NI Example Finder.
Hardware and Software Configuration
This section covers the hardware and software setup for the EtherCAT master and
AKD EtherCAT servo drive, and contains instructions about using the NI SoftMotion Module
to configure and test your system.
Note
This document uses a CompactRIO controller as the EtherCAT master. Refer
Configuring a PXI or Industrial Controller Master
for setup instructions for those
devices.
The following procedure assumes the device is configured with the factory default settings it
shipped with. If the device has been previously configured, use Kollmorgen WorkBench
software to restore it to the default settings before proceeding. Refer to the
Parameter Load/Save
topic in the
Using Parameters and the Terminal Screen
section of the Kollmorgen WorkBench
help for more information.
