NARDA FieldMan, Руководство пользователя

Страница: 60 / 126

8 Operating modes
60
FieldMan Narda
8.2 FIELD STRENGTH
The
FIELD STRENGTH
operating mode is used to measure the field strength or flux den-
sity and enables the numerical display of the measurement results for a defined fre-
quency range. This frequency range can be broadband or band-limited. A time curve
(
Time Curve
) can be activated as a rolling memory for the measurement results.
This is the most commonly used mode for broadband or band-limited measurements.
8.2.1 Measurement settings
The
MEASUREMENT SETTINGS
menu provides quick access to the most important
measurement settings for the selected operating mode.
Function
1)
Description
Reset Results
Reset measurement results
Zero
Offset correction (HP-01 probe only)
⇒
See
10.3 Offset correction – Zero on page 102
.
Frequency Span
Frequency range
Field
Electric or magnetic field
Range
Measuring range
Unit
Unit
Low Cut Filter
Filter for suppression of low frequencies (low cut filter)
Detector
Detector type
Time Curve
Show/hide time curve display
Time Span
Timeline for time curve display
Single Run
Automatic stop of the measuring sequence
(only visible if
Time Curve
=
On
)
Pulse Detection
Short integration time for HF measurement, e.g. for more
accurate measurement of short radar pulses (only visible
with suitable HF probes)
Averaging Time
Time for moving averaging
1) The available parameters depend on the selected operating mode and the connected probe
type.