NARDA ELT-400, Руководство по эксплуатации

Страница: 37 / 100

ELT-400 5 Operation and use
5-9
5.3.3 Selecting the detection mode (DETECT)
Three modes of detection are available depending on the selected operating
mode:
ª
Detection mode / Detector: see page C-2
⇒
Press the DETECT key until the required detection mode is shown in the
display.
Note: The selected detection mode is applied immediately.
The measurement value is valid as soon as the switch over occurs.
Detection mode Field
strength
mode Exposure
STD mode
STND (Standard)
The detection mode specified in the appropriate
standard is set automatically. You can also select RMS
and PEAK detection if required.
x
RMS (root mean square value)
The RMS value resulting from the isotropic
measurement is derived from the RMS values for the
three individual measurement axes.
x x
PEAK (peak value)
The peak value of the isotropic measurement is
derived from the peak value of the field vector. The
phase in the three individual measurement axes is
taken into account.
x x
Table 5-2 Available detection modes, depending on the selected operating mode