TMCSS and TMCK
TORCH MOUNTING CABINET
INSTALLATION INSTRUCTIONS
W415-0692 / D / 10.19.11
:ROI6WHHO/WG1DSROHRQ5G%DUULH21/0*&DQDGD ID[ ZZZQDSROHRQILUHSODFHVFRP
INSTALLATION
TEMPLATE
TORCH
MOUNTING
FRAME
CABINET
1
X 4
X 2
NOTE: It is recommended that all fasteners be stainless
steel. (GSST8 ONLY)
NOTE: For the GT8, install the four wall mount brackets on
either side of the unit using the screws provided.
1.
Using the installation template (W122-0401) supplied,
determine the best mounting location for your new Torch. (refer
to your manual for clearances) Mark all 14 hole centres on the
wall (surface) using the template.
2.
Remove the template. Depending on the surface and
fasteners, drill the appropriate holes. Hold the Torch up, aligning
the mounting brackets to the mounting holes. Secure the Torch
to the wall using the appropriate fasteners.
NOTE: The GT8
Torch has been designed to have a 1 1/4” clearance between
the rear outer panel and the mounting surface.
3.
Start the fasteners into each of the six remaining mounting
holes. With the defl ector positioned on the top of the frame, align
the keyholes to the heads of the fasteners and slide the frame
down onto the fasteners. Ensure the frame is plumb and level
before tightening the fasteners.
NOTE: It is recommended
that the gas and electrical be connected to the appliance
at this stage. Both must enter the appliance at the opening
created between the bottom of the Torch and the bottom of
the mounting frame.
4. Slide the front of the cabinet over the mounting frame,
ensuring the “mesh” is to the top. Begin with the bottom so that
it fi ts under the trim mounting bracket. Start each of the four
screws (supplied) through the slots. Once the cabinet has been
adjusted for depth the four screws can be tightened.
NOTE: The TMCSS can be installed on either the GT8,
the GVFT8 or the GSST8, however the TMCK is only to
be installed on either the GT8 or the GVFT8.
NOTE: Ensure the clearances to combustibles
outlined in your manual are maintained. The
cabinet is adjustable to suit most installations.
!
WARNING
Before starting the installation remove the
protective layer from all three components that
make up the GSST8 (cabinet, frame, and Torch)
2
MOUNTING
BRACKET
4
3
KEYHOLE
