12
The XP-600 is constantly monitoring its own components, as well as all critical services, such as AC
Power and the Telephone line, to insure that it is always ready to provide the protection for which it was
designed. When a system trouble does occur, it will caution you by lighting the yellow
H
SYSTEM
light
and beeping the keypad buzzer. If you cannot immediately clear the system trouble, the system can still
be used. Simply press
D
to view the trouble as described below, and then arm the system.
In order to determine the nature of the trouble, press
D
, count the number of keypad beeps and ob-
serve the number of the illuminated zone light. Refer to the following table to determine the cause of the
trouble. If there is more than one trouble to be viewed, pressing
D
will scroll to the next, and then exit
the
H
SYSTEM
mode if there are no additional troubles to view.
Keypad Beeps or
H
SYSTEM
Flashes
Zone light
ON
System Trouble
Condition
Action
1
Beep with
Y
flashes
1
AC Power Failure
This trouble will occur if AC power is not present. Make sure
system transformer is plugged into AC receptacle and check
circuit breaker, otherwise call installing company for service.
1
Beep
2
Low Battery
If there has been a recent power failure, the battery may be
partially depleted and must be recharged by the control panel.
If the trouble does not go away in 24 hours, call installing com-
pany for service.
1
Beep
3
Communication
Failure
The system was not able to report to central station. If this is
due to a temporary interruption in the telephone service, the
trouble can be cleared when the service is restored by press-
ing
D
. Otherwise, call installing company for service.
1
Beep
4
Telephone Line Cut The telephone line has failed. If telephone service has been
temporarily interrupted, the trouble will clear it is when re-
stored. Otherwise, call installing company for service.
2
Beeps
1
Bell/Siren Trouble
There is a problem with the Bell or Siren. Call installing com-
pany for service.
H
System Troubles
