The DAX/2 System – Version 8.0.5
10
2.
Deploy the pulse charger. The pulse charger may take up to 2 minutes to charge.
3.
Press the button on the top of the pulse charger to fire it, once the tone is sounded.
Using
another NS or NS compatible unit to jump-start
a powered-down unit:
1.
Place the unit within 10 m of the unit in trouble.
2.
Via the remote console, type:
zap <amount>
(where
<amount>
is the number of kilojoules to transmit.)
Alternatively, instruct the unit to perform:
!zap <amount>
to obtain the same effect.
The standard active draw when moving, etc. is averaged in for a unit is approximately 1 kW, so it is advisa-
ble to provide at least 500 kJ of power when rescuing a unit in this manner. This will provide it with enough
power to use its FTL (faster-than-light) drive to teleport home.
Low power
When your unit’s power falls below 20%, a warning message will play and you will notice that it begins to speak more
slowly. This is the first sign that you should get it charged at the next opportunity.
Below 10%, the unit’s FTL drive, SMS radio, preamplifier, and power amplifier will shut off to conserve power. These sys-
tems can (and should) be re-enabled if necessary to reach a charger.
Below 5%, the unit will automatically power down for safety. Every time the unit is powered on below 5% power, the same
systems that disabled at the 10% power threshold will automatically shut down again, plus the cortex, GPS, identification
processor, and the rapid movement subsystem. These systems can still be restarted, however, using the normal methods.
For more information on subsystems and managing them, see page 11.
Содержание DAX/2
Страница 41: ...nanite systems com 1 800 5 NANITE 562 6483 ...