Shanghai Nanhua Electronics Co., Ltd Tel
：+86 021-39126868
Fax
：+86 021-39126868ext 808/818
Web
：
www.nanhua.com
E-mail：
Add: Building 9, No.
1755Wenbei Rd, Jiading district Shanghai 201802
All rights reserved by Nanhua,
without the written authorization of the Nanhua, any part thereof shall not be reproduced or transmitted in any form.
FR15 Synchronizing Control Box
FR15-E3-V12
1 /
3
Application
Design for the fault alarm output,ON/OFF and flash frequency control for aviatioon obstruction light.
Major functions&features
• Control the aviation lights flash synchronously.
• With fault alarm function. When any light fails, there will be with alarm indicator and fault signal
output.
• Alarm signal is relay contactor output, no power source.
• With photocell/manual switchover device. If you do not need photocell function, it could change
to manual control model by this device.
•• Light-operated switch use PJ003 to realize its function. Fault alarm function about photocell can
be customized.
• AC type control box can customize the GPS synchronization: Synchronize all aviation lights
which are controlled by different control box.
• With disturbance switching function. When lead light fails, standby light will switch on
automatically.(Customized).
Specification
Voltage
DC48V
AC110V~AC240V
Control method
Steady burning/flash
Control circuit
branch
4 ways
Flash frequency
20~60
times/minute
（adjustable）
Photocell sensitivity
70~100Lux(on/off)
Alarm output
dry connect(relay) output
Ambient
temperature
-30˚C ~ +70˚C
IP code
IP65
Humidity
10% ~ 95% (
no coagulation
）
Wiring Connection
•Power connetion terminal. Product has AC and DC type. Please see the following diagram:
•Aviation light’s connction terminal. Product has AC and DC type. Please see the following
diagram
:
For control box with faulty switch over function, Light 1 is lead light’s outputting, Light 2 is
standby light’s outputting. When Light 1 works, Light 2 is rest. In case Light 1 fails, Light 2
start to work automatically.
•• Connection terminal of aviation light’s faulty alarm. When light fails, this terminal will be
closed. Following diagram is “Light1 fault” terminal.
• Please see following diagram for photocell connection terminal.
Operation:
• Manual/Automatic switchover：
Set the dial switch to the left side, the control panel is in auto status. In this case, control
box will switch on/off the lights at nighttime/daytime automatically. Set the dial switch to
the middle, control box is in manual status. In this case, the lights will work. Set the dial
Installation（unit:mm）
Connection diagram
FR15
Series
Outdoor
