NAMCO CRISIS ZONE DX, Руководство оператора

Страница: 58 / 89

Page 57
5-2-3-4 Motor Test
1. Select “Motor Test” on the I/O menu screen to test the gun Motor.
The following screen is displayed.
2. The gun motor will operate when the trigger pulled.
When the gun is pointed at the screen, “INSIDE” is displayed next to ‘GUN
SIGHT’ (item a)
When the gun is pointed away from the screen, “OUTSIDE” is displayed
next to ‘GUN SIGHT’ (item a).
If these indications do not appear properly, adjust the Gun Sight (see
section 5-2-3-2 page 52) before checking the Gun Motor.
3. Point the Gun torwards the screen and keep the trigger pulled for 10
seconds. “ON appears next to ‘GUN TRIGGER’ (item b), and the counter
counts down. When the Gun is pointed away from the screen or the trigger
is released, the counter restarts.
If the motor is normal “OK” is displayed next to ‘MOTOR’ (item c) after the
countdown is completed.
If a problem is detected with the motor, “NG” is displayed next to ‘MOTOR’
(item c)
When a motor error is detected a message is displayed at (item d), and the
motor stops operating.
4. Select EXIT and press the enter switch to return to the I/O TEST screen.
Note: Ensure that this motor test is conducted after replacing the Gun.
I/O TEST
DIP 3 12345678 [ON:RED]
MOTOR TEST
GUN SIGHT OUTSIDE ....................................... (a)
GUN TRIGGER OFF 10”00 ....................................... (b)
MOTOR ?? ....................................... (c)
Error message displayed here ....................................... (d)
EXIT
SELECT SW : CHOOSE ENTER SW : ENTER