NAL Research Corporation (451-93156-002A)
40
Exec Command: +GMM
Query the A3LA-RM RF board model. This command is similar to +CGMM.
A.8.58 +GMR – Revision
Exec Command: +GMR
Query the A3LA-RM RF board revision. This command is similar to +CGMR.
A.8.59 +GSN – Serial Number
Exec Command: +GSN
Query the A3LA-RM IMEI. This command is similar to +CGSN.
A.8.60 +GCAP – General Capabilities
Exec Command: +GCAP
Query the A3LA-RM’ overall capabilities.
A.8.61 A – Answer
Answer immediately. This causes the A3LA-RM to answer the incoming data or voice call.
A.8.62 D – Dial
Dial a data or voice call number. The dial command causes the A3LA-RM to enter originate
mode and act as an auto dialer for connection to other modems or voice lines. The usual format
is ATDnx..x where n is a Dial Modifier and x is a number. The following are valid numbers:
0123456789*#ABC. Dial modifiers are used to alter the manner in which the A3LA-RM dials.
L
Redial last number
+
International dialing prefix. Allows the international access code to be omitted from
dial string.
>
Direct dial from phonebook locations. See subsection below for further details.
;
Start up a voice call. This modifier should be given after the dialing digits (or
modifiers).
Any character received from the DTE during the call establishment phase will cause the call
attempted to be terminated.
A.8.62.1 D> – Direct Dial From Phonebook
The A3LA-RM and SIM contain phonebooks which have a phone number and an alphanumeric
field for each phonebook entry location. The use of V.25ter dialing command ensures that direct
dialing from phone memory and SIM phonebook is possible through ordinary communications
software which just gives the phone number field to be filled and then uses the D command to
originate the call. Available memories may be queried with Select Phonebook Storage test
command +CPBS=?, and location range for example with Read Phonebook Entries test
cCPBR=?.
Execute commands: D><str>[;]
Originate call to phone number which corresponding alphanumeric field is <str> (if possible, all
available memories should be searched for the correct entry). <str> is of string type value and
should enclosed by ““ (e.g., “John”).
