Nakanishi AL-C1204, Руководство по эксплуатации

Страница: 1 / 8

9
English
1 . CAUTIONS FOR HANDLING AND OPERATION
■
Read these warnings and cautions carefully and only use in the manner intended.
■
These warnings and cautions are intended to avoid potential hazards that could result in personal injury to the
operator or damage to the device. These are classified as follows in accordance with the seriousness of the risk
.
Class Degree of Risk
WARNING
A safety hazard could result in bodily injury or damage to the device if
the safety instructions are not properly followed.
CAUTION
A hazard that could result in light or moderate bodily injury or damage to
the device if the safety instructions are not followed.
WARNING
① Handling
Connection to the Air Line Kit should be performed by a person with experience with
compressed air and air compressors.
② Air Pressure
Compressed air is required. Do not exceed an air pressure of 1.0MPa at primary side and
0.85MPa at secondary side of the Air Line Kit.
③ Use of Clean Air
Do not use compressed air contaminated with chemicals, oil compounds, organic solvents,
salinity, or corrosive gasses to avoid damage to the device.
④ Connection of Hose
Connect the input hose securely to avoid accidental disconnection during use. Input pressure
should never exceed 1.0MPa.
Pressure exceeding 1.0MPa may cause the hose to rupture.
⑤ Inlet and Outlet Parts
Do not hit, impact or cause shock to the Inlet or Outlet Connector Parts. Never put undo stress
or load on the Inlet or Outlet Connector Parts. Any damage to these components can cause air
leakage and the inability of the outlet quick disconnect to adequately secure the tubing.
⑥ Dropping the Air Line Kit
When installing the Air Line Kit, securely install it on a flat, level surface. If the Air Line Kit is
dropped, damage to the Air Line Kit and injury to the operator is possible.
⑦ Air Regulator Bowl
・ The bowl is made of a polycarbonate.
Do not use the Air Line Kit in conditions where chemicals or organic solvents are present in
the atmosphere.
・ Do not remove the bowl guard. Using the Air Line Kit without the bowl guard may cause
injury to the operator should the bowl burst.
・ When removing the bowl from the regulator, remove all pressure from the Input and Outlet
sides of the Air Line Kit.
Thank you for purchasing the "AL - C1204" Air Line Kit for brushless motors and motor / spindles. This Air Line Kit
will supply clean and dry cooling air to the motor and spindle. THIS AIR LINE KIT IS NOT A SUBSTITUTE FOR
AN AIR DRYER. A Compressor is required to serve this Air Line Kit. Read this, the CONTROLLER and the Motor /
Spindle Operation Manuals carefully before using. Always keep this Operation Manual in a place where a user can
referred to for reference at any time.