Page | 28
SWAP BUTTONS (BSWAP)
– Set this to swap the location of the main and aux buttons. Only recommended if both
are momentary.
USE BOOT SOUND (BOOT)
– Indicates if when the saber starts it should play the boot sound, or the font.wav from
the first font.
LOWPWR
– Time in seconds that the saber is in idle before it goes into low power mode, cutting the accent LEDs
and the motion. A single aux press (or main button tap for a single button) will wake the board. Set to zero (0) to
never enter low power.
NSTRP
– Applicable only when using a WS2812 (NeoPixel) blade. This defines the length of a single strip of the
blade – for example, when using a triangular prism blade, if the lengths of each strip are 144, 145, and 144, then
choose 145 or the side with the maximum length. Currently the maximum number supported is 255.
After making all the edits desired, to go File->Save in the program to save the new configuration settings. Repeat
for any other fonts where the effects are going to be configured before transferring the files back to the micro SD
card.
5.5.2.
MOTION
This section contains the motion sensitivity settings. Each setting is described below.
