Page | 16
Figure 8 – Diagram with a small shaft-less motor running of the C4- pad. For accessories that require more voltage/amperage, direct battery
power can also be used.
4.8.
CROSS-SABER WIRING
For those that want to mimic the saber with two side quillion or cross-guard blades that have the delayed
extension, the following wiring diagram is provided. This supports a saber where all three blades are the same
color, with a secondary flash color for either the main blade or all blades.
I’ve provided the wiring for a TriCree though any other LED would be similar. If using a TriCree I recommend only
hooking up two of the three die for the side LEDs to prevent battery drain and to ensure that a single channel does
not get too hot.
Note that when using Red or Amber die resistors would be needed between the die and the appropriate Cn- pad.
