1385, boul. Lionel-Boulet, Varennes, Québec J3X 1P7 Toll Free: 1 888 514-8007
•
Tel: 438 338-1101
•
Fax: 450 922-5900
www.nagasinnovation.com
34
of
35
c.
Press the jog knob for 2 seconds to confirm the value
7.
Turn the jog dial up to
HSP
(High speed
,
equivalent to the second speed) then
push the jog dial.
a.
Change settings if needed (60 Hz default) by turning the jog dial.
b.
Press the jog knob for 2 seconds to confirm the value.
8.
Press the
ESC
button many times until the display shows the current frequency of the drive.
12.2.
Variable speed VFD
When the unit is running: the display should show the current frequency of the drive.
1.
Push on the jog dial (3). The screen should display
rEF-
.
2.
Turn the jog dial up to
COnF-
(configuration) then push the jog dial.
3.
Turn the jog dial up to
FULL
then push the jog dial.
4.
Turn the jog dial up to
SET-
(settings) then push the jog dial.
5.
Turn the jog dial up to
LSP
(minimal speed
,
equivalent to the input signal
(0 Volt.) then push the jog dial.
a.
Turn the jog dial to a minimum speed frequency (25Hz default).
b.
Press the jog knob for 2 seconds to confirm the value.
6.
If
LSP
has been set to a value below 25Hz otherwise, you can skip this step
a.
Turn the jog dial up to
Ftd
(frequency threshold) then push the
jog dial.
b.
Change settings with the same frequency value found for the
LSP
(
Low Speed
Hz) by turning the
jog wheel.
c.
Press the jog knob for 2 seconds to confirm the value.
7.
Turn the jog dial up to
HSP
(High speed
,
equivalent to the input
signal 10 Volt) then push the jog dial.
a.
Change settings if needed (60 Hz default) by turning the jog dial.
b.
Press the jog knob for 2 seconds to confirm the value
8.
Press the
ESC
button many times until the display shows the current frequency.