INTRODUCTION
GETTING STARTED
WHAT’S IN THE BOX
Packed with your C 426 you will find
·
An AM loop antenna.
·
A FM ribbon-wire antenna with balun.
·
A detachable AC power cord.
·
An audio cable connector (RCA-to-RCA lead).
·
The TNR 1 remote control with 2 (two) AAA batteries.
·
This owner’s manual version in CD-ROM.
SAVE THE PACKAGING
Please save the box and all of the packaging in which your C 426 arrived.
Should you move or otherwise need to transport your C 426, this is by far
the safest container in which to do so. We’ve seen too many otherwise
perfect components damaged in transit for lack of a proper shipping
carton, so please: Save that box!
CHOOSING A LOCATION
Choose a location that is well ventilated (with at least several inches to both
sides and behind), and that will provide a clear line of sight, within 23 feet/7
meters, between the C 426’s front panel and your primary listening/viewing
position—this will ensure reliable infrared remote control communications.
Avoid placing the unit in direct sunlight or near sources of heat and damp.
It is perfectly possible to stack the C 426 on top of other components.
QUICK START
In case you simply cannot wait to experience the performance of your
new C 426, we provide the following “Quick Start” instructions to get you
underway.
Please make all the connections to your C 426 with the unit unplugged. It is
also advisable to power down or unplug all associated components while
making or breaking any signal or AC power connections.
1
Use the RCA-to-RCA lead to connect the left and right output of the
C 426 to the tuner input of your amplifier.
2
Connect AM and FM antenna.
3
Connect the supplied AC cord to the C 426 AC mains input and then
plug into an AC outlet. The Standby LED indicator embedded around
the bezel of the STANDBY button will illuminate amber.
4
Plug the AC mains plug also of your amplifier into the AC outlet. Power
up your amplifier and set it to the tuner input where the C 426 is
connected.
5
Press the front panel STANDBY button to turn ON the C 426. The
Standby LED indicator will turn from amber to blue and illuminate the
VFD.
6
Toggle front panel’s [FM/AM] button to select AM or FM band.
7
Toggle front panel’s [PRESET/TUNE] button to switch between “Preset”
and “Tune” mode. Select TUNE mode (“TUNE” scrolls through the VFD).
8
Rotate the [PRESET/TUNE] control knob to select desired station.
5
EN
G
LI
SH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
