INFRARED LEARNING
Infrared (IR) Learning enables any non-NAD remote control learn IR remote
control codes. With the learned codes, the configured non-NAD remote
control can be used to command or operate the C 328. The IR remote
control codes are based from the supplied AMP 3 remote control.
HOW TO LEARN IR REMOTE CONTROL CODES
1
Press and hold at the same time front panel BASS EQ and
a
SOURCE
buttons until “F1” appears on the front panel display. The display of “F1”
indicates that the unit is at IR learning mode.
2
A total of twelve IR remote control codes can be learned. These codes
are defined as “F1, F2….F12” and are identified by their allocation in the
AMP3 remote control layout below.
3
Use front panel
a
SOURCE or SOURCE
s
to toggle through F1, F2…F12.
4
For example, to learn “F5” (Volume Up), toggle
a
SOURCE or SOURCE
s
until “F5” is shown in the front panel display.
5
Press BASS EQ and “F5” will begin to flash.
6
While pointing the non-NAD remote control to the front panel display,
press the corresponding button on the non-NAD remote control where
“F5” will be learned. “F5” will stop flashing, briefly stay solid and then the
next command (F6) is displayed. The solid “F5” indicates that “F5” code is
already learned by the non-NAD remote control.
7
Repeat the same process above to learn other IR remote control codes.
8
To save the learned IR remote control codes and at the same time exit IR
learning mode, press and hold the front panel BASS EQ and
a
SOURCE
buttons until the front panel display reverts to volume level display.
OPERATION
USING THE C 328
AMP
3
BASS
DIM
AMP
3
BASS
DIM
F1
F2
F3
F4
F11
F5
F6
F7
F8
F9
F10
F12
➜
10
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ