background image

 

OVERVIEW 

The TP18SX-HP is a professional carpet extractor, with excellent performance. It has a built 
in chemical dilution system for the cleaning stage. This means that you will never have to 
pour  chemical  into  the  solution  tank.  Once  complete,  with  the  turn  of  a  valve  you  will  be 
rinsing with clean water. 

 

Safety instructions (read carefully) 

 
Every  electrical  device  must  be  used for  its  particular function  only,  respecting the  manufacturer’s 
instructions. Failure to adhere to the instructions could result in serious person injury, electric shock, 
fire or explosion. 
Please, read these safety instructions carefully and ensure you understand them prior to using the 
machine.  The  following  information  signals  potentially  dangerous  conditions  to  the  operator  or 
equipment. 

 

WARNING: Fire or Explosion Hazard.  

 

  Do not spray water near electrical outlets.  

  Do  not  use  the  machine  to  spray  or  to  vacuum  dust,  corrosive  liquids  (acids  or  bases)  and 

explosive or flammable liquids.  

  Do  not  use  the  machine  in  an  explosive  atmosphere.  This  machine  is  not  equipped  with  an 

explosion proof motor. The electric motor will spark when powered on which could cause a flash 
fire or explosion. 

  Never  use  flammable  liquids  or  operate  machine  in  or  near  flammable  liquids,  vapors  or 

combustible dusts.  

 

WARNING: Electrical Hazard. 

  Before putting the machine’s plug in the electrical outlet, check that the voltage available is the 

same indicated on the label of the machine. 

  Be sure that the electrical system is well grounded. 

  Verify that the electrical plug complies with the outlet. 

  Do not modify plug. 

  Do not use adapters or multiple sockets.  

  Do not use this machine with an extension cord. 

  Take care of the electrical cable. It must be in good condition and protected from water, tears and 

chemical  agents.  Do  not  repair  the  cable  in  case  of  tears,  but  replace  it  with  a  new  one.  The 
cable must be replaced by the manufacturer or its service agent or a similarly qualified person in 
order to avoid a hazard. 

  Do not pull the machine by the cable. 

  Do not use the cable to pull the plug out of the electrical socket.  

Содержание TP18SX-HP







Отзывы: