Rev. 2-28-22
P/N C-00394
ICU 2400 Automatic Sliding Door Owners Manual
3 of 7
SECTION 4.1: Service Availability
Door products are distributed through a nationwide network of authorized suppliers for sales, installation, and service.
Immediately contact the Door Manufacturer or the Authorized Door Manufacturer Representative, if service must be
performed on an automatic door system.
SECTION 4.2: Safety Standard Compliance
The automatic door system was designed to comply with the latest operating and safety standards. To ensure continued, safe
operation it is important that:
X
The door system is maintained in compliance with industry standards.
X
Proper decals/labels are applied and maintained on doors.
X
All doors should be checked by an AAADM certified inspector at least annually.
The American Association of Automatic Door Manufacturers, has established a program to certify automatic door inspectors.
Through this program, inspectors are trained to check door systems for compliance with the appropriate version of an ANSI
standard. In the United States, ANSI Standard 156.38 (Low Energy Power Operated Sliding and Folding Doors) applies.
SECTION 4.3: Limited Warranty
NABCO Entrances Inc. provides to its customer a limited warranty on products. The warranty is:
NABCO ENTRANCES INC. will exchange or repair, F.O.B. the plant, any component found defective
in workmanship and/or material, subject to NABCO’s inspection, for a period of one (1) year
after installation or 18 months after manufacture, whichever comes first. Warranty does not
include field service labor. The installing contractor/customer will be responsible for installation
and field service. This is NABCO ENTRANCES Inc.’s sole warranty.
This warranty does not cover loss or damages resulting from causes beyond the manufacturer’s control, misuse, neglect,
accidents, windstorms, or other acts of God, or acts of terrorism. Warranty is for normal use and service. The warranty does
not apply to equipment that has been repaired or altered so as to adversely affect conditions of operation. Warranty will not
obligate NABCO Entrances or damages resulting from such alterations, misuse, or acts of God, or acts of terrorism.
SECTION 4.4: Information Provided by Door Supplier
Note: To obtain an AAADM Daily Safety Check video, please go to http://www.aaadm.com/daily-safety-check/index.html
X
Instruction on how to conduct the Daily Safety Check.
X
Location of activation Switches and Sensors with instruction of their use.
X
Circuit breaker or main power disconnect location for each door system.
X
Contact number to call for service, or inquiries about the Door system, and/or to report concerns.
X
An AAADM inspection form, or a Work Order signed by an AAADM certified inspector.
X
Affixed to the Door, a completed Annual Compliance Inspection label, at the bottom of the Safety Information label.
X
Warranty information for each door.
CHAPTER 5: GENERAL SAFETY
Pay attention to the following safety items and perform checks periodically where noted.
X
Force:
• Force to prevent the door from closing.
• If the door is equipped, force to Breakout the door.
• Force to open door in the event of a power failure.
X
If equipped, Breakout Mode:
• When the door (or door including a Sidelite) is pushed into Breakout mode, check that the door will not activate.
X
Strike Stile:
• With door open, grasp the Strike Stile of door and attempt to move it vertically and horizontally. There should be
very little, if any, looseness between door and glass, and/or connections between door and operator