Rev. 061209
105TX-SL Instruction Sheet
PACKAGE CONTENTS
One 105TX-SL unit
UNPACKING
Remove all the equipment form the packaging, and store the packaging in a safe place. File any
damage claims with the carrier.
APPLYING POWER (Top View)
Unscrew & Remove the DC Voltage Input Plug from the top header.
Install the DC Power Cables into the Plug (observing polarity on unit).
Plug the Voltage Input Plug back into the top header.
Tightening torque for the terminal block power plug is
0.5 Nm/0.368 Pound Foot
.
All
LED’s will flash ON Momentarily.
Verify the Power LED stays ON (GREEN).
Note:
Either V
1
or V
2
can be connected to power for minimal operation. For redundant
power operation, V
1
and V
2
plugs must be connected to separate DC Voltage sources.
Use wire sizes of 12-28 gauge. The power cord should be limited to less than 10 meters
in order to ensure optimum performance.
Recommended 24V DC Power Supplies, similar to:
100-240VAC:
N-Tron NTPS-24-1.3, DC 24V/1.3
To download the User Manual please visit the following location: www.n-tron.com/html/tech_docs.html
