NAT-AMC-ZYNQUP-FMC
T
ECHNICAL
R
EFERENCE
M
ANUAL
V1.1
Q
UICK
S
TART
- 11 -
3.3.
Voltage Requirements
3.3.1.
Power supply
The power supply for the
NAT-AMC-ZYNQUP-FMC
must meet the following specifications:
+12V / 7A max.
+ 3,3V / 0.15A max.
3.3.2.
Hot-Swap
The
NAT-AMC-ZYNQUP-FMC
supports hot-swapping, which means that the board can be
inserted or extracted during normal system operation without affecting other modules.
Make sure to follow the procedure
exactly
to prevent the
NAT-AMC-ZYNQUP-FMC
or the
system it is plugged into from damage!
Insertion of a hot-swap-capable Module
•
Ensure the module and the backplane/carrier support hot-swapping
•
Ensure that the hot-swap-
handle is in “unlock”
-position (pulled out)
•
Push the
NAT-AMC-ZYNQUP-FMC
carefully into the dedicated connector until it is
completely inserted
•
The blue HS-LED turns solid on
•
With pushing the hot-swap-
handle to “lock”
-position, the HS-LED starts blinking and
the IPMI-Controller of the backplane/carrier detects the board
•
If the information provided by the
NAT-AMC-ZYNQUP-FMC
is valid, the
backplane/carrier enables payload power and the blue HS-LED turns off
Extraction of a hot-swap-capable Module
•
Pull the hot-swap-
handle in “unlock”
-position
•
The blue HS-LED starts blinking
•
The IPMI-Controller of the backplane/carrier disables payload power
•
The HS-LED turns solid on
•
Pull the
NAT-AMC-ZYNQUP-FMC
carefully out of the backplane/carrier