MyWam Yeti, Руководство по эксплуатации и обслуживанию

Страница: 21 / 35

YETI Edition 7 / 2022-10-25
21 | P a g e
clamps (See Fig. 11.3.2), while the two front belt straps are attached to the stroller frame under the rail
narrowing (sideways ) by passing the belt through the factory loop in the tape (See Fig. 11.3.3)

Adjustment. To adjust the length of the Abduction and stabilizing belts, you must move the
adjusters on the front belt straps up or down.

Use. In order to put the user on the Abduction and stabilizing belts, put the user on the installed
belts, then wrap the
user’s
leg and fasten both belt buckles to both front straps.
In order to remove the Abduction and stabilizing belts from the user, unfasten both belt buckles from the
front straps.
Seat minimizing kit
The Yeti and the Yeti Young stroller is equipped with two pairs of two inserts,
two right and two left (Fig. 11.4). They are used to adjust the inside dimensions
of the seat width. The upholstery of the seat minimizing kit is removable thanks
to the zipper sewn in, which allows it to be replaced or cleaned.

Assembly. The inserts are installed anywhere in the stroller, at any
height adapting to the patient's indications. Installation is done with Velcro on
the bottom, back and outer side of the insert.

Disassembly is done by removing the element - pulling the velcro from
the stroller upholstery.
The head restraint
The headrest is used to stabilize the user's head and is a softening element of
the seat on the head section (Fig. 11.5). The headrest upholstery is removable
thanks to the zipper sewn in, which allows it to be replaced or cleaned.

Mounting the headrest with Velcro at the back of the headrest at the
selected height.

Disassembly is done by removing the element - pulling the Velcro from
the stroller upholstery.
Fig. 11.3.2 Fig. 11.3.3
Fig. 11.4
Fig. 11.5