v e r . 3 z d n i a 1 8 . 0 5 . 2 0 2 0
P e g a z
23
Therapeutic table
The Pegaz stroller can be equipped with a non-slip therapeutic table with a
maximum load of 3 kg (Photo 11.2). To assemble the table, slide the open
fastening clamps onto the main element of the frame, and then tighten the
clamps until they are completely closed. Make sure it is securely attached
by pulling it vigorously - the table should remain in place. To disassemble
the table, unfasten the clamping clamps and remove the table from the
trolley frame.
The therapy table is used alternately with a safety barrier and is an essential
structural element of the wheelchair.
WARNING!
For structural reasons, the stroller must have a footrest and a
railing or therapeutic table.
Loin cushion
The loin cushion is an additional piece of equipment that increases the comfort of using the wheelchair
by softening the backrest in the lumbar section (Photo 11.3). The cushion is installed by attaching it to the
back with velcro.
Headrest
The headrest is an element of optional equipment (Photo 11.4). It performs both softening and stabilizing
functions. To adjust the height of the headrest, attach the it with velcro at the correct height of the
backrest. Then, for better stability, drag the headrest straps fitted with velcro through the backrest
openings and attach them behind the backrest.
Narrowing pads
The Pegaz stroller is equipped with two narrowing inserts. They are used to adjust the inside dimensions
of the seat width (Photo 11.5). The inserts are mounted by attaching them with the longest vertical edge
of the pad to the outer edges of the backrest and to the side elements of the trolley frame using a velcro
strap
Photo 11.2
Therapeutic table
Photo 11.3
Photo 11.4
Photo 11.5
Loin cushion
Headrest
Narrowing pads
