P e g a z
v e r . 3 z d n i a 1 8 . 0 5 . 2 0 2 0
30
Cleaning and care
Small leaks and stains can be removed from the surface with a kitchen sponge and using clean, warm
water. Stains should be removed immediately after they appear on the surface of the stroller. Do not rub
- rubbing will spread the stain to a larger surface and may distort the texture of the fabric. The treatment
of water stains such as stains from food, drinks and vegetable oils is as follows:
•
Dry the stain by pressing a white paper towel, handkerchief or absorbent clean cloth over its entire
surface.
•
Soak a small piece of cloth with a weak solution of detergent and warm water (or cold water in the
event of blood staining) and rinse the stain by removing it from the outside to the inside to prevent
it from growing. Do not use a too wet cloth, as excessive amount of liquid may cause rims after
drying or enlargement of the stain and damage of the upholstery or foam inside.
•
It may be necessary to repeat the above operation depending on the type of stain and the amount
of stained material. The above operation should be continued until the stain is completely
removed, but always remember to remove excess moisture from the stained material before
rinsing again.
•
Then rinse the material using only lukewarm water without detergent, using a clean sponge or a
clean white cloth. As above, rinse the material in place after the stain in the right direction, i.e. from
the outside in.
Disinfectants that do not contain organic solvents can be used in accordance with the manufacturer's
instructions. Do not dip the fabric. Make sure the product is always dry before use. Do not use organic
solvents or dry cleaning agents.
For disinfection, you can use a small amount of ordinary household bleach, diluted with water with a
maximum concentration of 3% bleach.
ATTENTION!
The manufacturer is not liable for damages resulting from the use of inappropriate cleaning
products.
17.
Storage of the stroller
The stroller should be stored in a clean, dry and well ventilated room, preferably at 0-35 Celsius degrees.
Preparation of the stroller for long-term storage
In order to prepare the Pegaz stroller for long-term storage, secure the product and perform all service
operations in the "Periodic Inspections" chapter as if they had occurred.
The stroller should be stored in a clean, dry and well ventilated room.
Corrosion protection
To avoid corrosive damage to the stroller, it should not be used or left in wet and damp rooms. When the
truck is wet, wipe all wet parts with a soft cloth and dry with a light oil preservative. This does not apply
to the upholstery of the stroller, the provision of cleanliness and maintenance of which is described in
detail in the Cleaning and care chapter.
As a standard, the stroller is covered with the highest quality coatings. In the event of damage to the
varnish, protect the damage by applying a touch-up compound using the varnish proposed by the varnish
Manufacturer.
