MYTRIX Dreamweaver, Руководство пользователя

Страница: 53 / 56

Mytrix Technology - http://www.mytrixtech.com
2014 Mytrix Technology
All rights reserved Third Version
51
unplug the cooling fan of machine.
3、Q：Unable to load the filament
A
：
the reasons could be as follows
1. The temperature has not reached the best melting point of the filament. Adjust the
temperature, usually to increase.
2. The filament tie knots on the feeding tray, so the filament is stuck, cut it and then
adjust the filament, the print could be resumed.
3. The distance between the print platform and nozzle is too close, it will stuck the
nozzle. Low down the platform by adjusting the horizontal adjustment nuts.
4. The filament diameter is too large, cut it and change to a better one.
5. Nozzle is damaged, contact the customer serve if it is damaged for all kinds of
reasons.
4、Q：Displace during printing
A
：
possible causes
1. It could be winded or blocked, check whether the sliding cross-shaped base is
winded by filaments or blocked by a certain objects, eliminate them.
2. Too much dust on the Axis leads to the increase of friction. Use a tissue or alcohol
pad to clean the dust.
Chapter 11 Notice
Please read all of the following safety and operating instructions before use, to void
burn, electric shock, fire and other accident.
1. Please use this printer under right voltage and abide by local laws.
2. Do not throw, disassemble, squeeze, burn your 3D printer, do not load unsupported
filaments.