MYIRO myiro-9, Инструкция по эксплуатации

Страница: 35 / 44

Troubleshooting
9
Grasp the ends of the MYIRO-9 and tilt the MYIRO-9 body onto
the base again.
10
Open the cover
11
Tighten the two screws as shown until snug.
• If the screws are loose when measurements are taken, measurement
accuracy may suffer.
• Do not overtighten.
12
Close the cover.
13
Reconnect the cables and switch the MYIRO-9 back on.
When using MYIRO-9 with Auto Sheet Feeder
When using the MYIRO-9 with the Auto Sheet Feeder, the location of paper jams is usually in one of the following locations: Where the
paper feeds from the supply tray into the Auto Sheet Feeder and then into the MYIRO-9, within the MYIRO-9, or where the paper feeds
from the MYIRO-9 through the Auto Sheet Feeder into the exit tray. To clear paper jams, check each section.
1
Switch off the MYIRO-9.
2
Disconnect all cables (USB cable, LAN cable, AC adapter cable).
3
Remove the MYIRO-9 from the Auto Sheet Feeder.
• If the paper jam is inside the MYIRO-9, follow the procedure in the
preceding section “When using MYIRO-9 without Auto Sheet Feeder” to
remove the jammed paper.
4
If paper is still jammed, lift the lever on the left side of the supply
tray and swing the supply tray mechanism out to the right.
5
Remove any paper from inside the Auto Sheet Feeder.
6
Pull the handle on the inside cover to open the inside panel and
check that there is no paper inside the panel. If there is paper
there, remove it.
33