MYIRO myiro-9, Инструкция по эксплуатации

Страница: 29 / 44

Taking measurements
Measurements with the MYIRO-9 are controlled from software, such as Measurement Utility Software FD-S2w. For details on taking
measurements, please refer to the instruction manual for the software that you are using.
▍
Feeding Test Charts into MYIRO-9
• If the MYIRO-9 base mounting screws inside the cover are loose when measurements are taken, measurement accuracy may suffer. Be
sure that the screws are firmly tightened.
• When bringing test charts from another location, avoid sudden changes in temperature and allow the test charts to become
sufficiently adapted to room temperature before taking measurements. If condensation occurs on the test chart, it may cause sluggish
scanning or paper jams.
• The following test charts should not be fed into the MYIRO-9 or loaded in the optional Auto Sheet Feeder FD-A09. Doing so may cause
jams or may damage the MYIRO-9 and/or the FD-A09.
• Wrinkled, folded, or torn charts
• Charts with staples or paper clips
• Charts bound together in booklet form
• Charts that are glued together
• Charts with cutouts removed or which are cutouts
• Charts which are adhesive labels
• Permissible curl amount:
• When using test charts which are easily scratched, such as test charts on glossy paper, it is recommended that they be fed into the
MYIRO-9 by hand instead of using the optional Auto Sheet Feeder FD-A09. If the FD-A09 is used, the chart may become scratched.
Curl in feed direction
Curl radius when
paper is stood on
edge
Curl in scan direction
Lift when paper is
laid flat on table.
Downward curl Upward curl
Feed direction
Feed direction
Feed direction
Feed direction
Lift
Lift ≤
5 mm
≥ R60
≥ R70
Lift ≤
1 mm
R
27