20
Measurement
The instrument can be used to perform the following measurements.
CAUTION
Software is required to perform measurement. For details on the
measurement procedure, refer to the instruction manual for the
software being used.
Be sure to perform calibration before starting measurement. (See
pages 18 to 19)
Scan Measurement
Use the ruler included as a standard accessory.
1
Set the ruler on the chart so that
the
mark on the ruler is at the
end of the chart.
The scan operation should start
from the white part of the paper.
mark
Ruler
2
Place the instrument so that the
two feet are aligned with the
groove on the ruler, and then
align the limiting aperture with
the open end of the ruler.
Two feet
3
Press the measurement button.
Verify that the status indicator
changes from blue to white.
Measurement button
mark