Page
29
of
51
9.2
Installs in England, Scotland & Wales before 30
th
December 2022
Before following the steps below, check if your
zappi
has built-in tamper detection.
If no tamper detection is present, and it is before 30
th
December 2022 you do NOT need to retrofit a tamper
board and you may follow the below steps for set-up. If no tamper detection is present and it is after 30
th
December 2022, you cannot install the zappi legally until you have fitted a Tamper Board. Contact our Sales
Team for further information on ordering Tamper Board Retrofit Kits.
Step 1:
Select “Yes” as Smart charging
Regulations apply.
Step 2:
Read the screen carefully and check the date of the
install. If it is on or after the 30/12/2022 select “No” and
carry on to
step 3.
If the install is taking place before 30/12/2022 OR it was
previously installed prior to 30/12/2022 select “Yes” and
jump to
step 4.
Step 3:
You answered “No” to the previous question which means
zappi
is
required to have a tamper switch before install. Abandon installation until rectified
ensuring to leave the
zappi
in a safe state. Once tamper board has been fitted you
may begin set-up again following section 9.1 of this document.
Step 4:
Review settings and press + to confirm.
Note:
Selecting “1
st
device installed” will configure your
zappi
as Master and enable vHub.
Selecting “Additional device” will configure
zappi
as
Slave and disable vHub.
Step 5:
If you are connecting to the internet via
WiFi please
skip ahead to
Step 7
If you inserted an Ethernet cable earlier (section 9.4)
zappi
will detect this and attempt connect to the
home router automatically.
Step 6:
Once
zappi
has secured an internet
connection via Ethernet the below screen will show.
Skip ahead to
Step 14
for next steps.
Содержание zappi
Страница 7: ...Page 7 of 51 ...
Страница 16: ...Page 16 of 51 ...
