mychefcooking.com
PRODUCT MANUAL iBAKE MAX - DT.MP.IBM.2202.2
91
8.1.4.
Plastic exterior surfaces and control panel
To clean these more delicate surfaces (support of the control and the control itself) only a
very soft cloth and a cleaning product for delicate surfaces should be used.
Take special care with the control panel, Mychef will not be held
responsible for any damage caused to this element if it is not cleaned
properly.
As far as the drip tray is concerned, it allows water droplets that may fall due to condensation
from the steam from the inner door to run into the drain, so it is important to keep the drip
tray clean and free of obstructions.
Remove any pieces of food that may have fallen before cleaning. Then clean this part with a
cloth dampened with soap and water and finally rinse with plenty of water.
8.1.5.
Door gasket
Once the cleaning of the chamber has been completed, the washing process will continue
with the gasket that ensures the tightness of the chamber. It is important that this part of the
oven is clean and does not have any pieces of food embedded in it so that it can seal the
chamber well and heat, water or steam cannot escape when it is in operation.
To clean this rubber gasket, a cloth dampened with soapy water is sufficient. The whole area
is then rinsed and thoroughly dried.
The door gasket should not be removed from its contour for cleaning, it should only be
removed when it has to be replaced, if it has to be replaced, this can be done manually
without the aid of any tools.
