MyBinding Challenge Spartan 150M, Инструкция по эксплуатации

Страница: 14 / 22

6.0 Operation
13
6.4 Line Light
The Spartan 150 comes standard with an LED line light. The line light switches on and stays on
whenever the power is on. To use, simply align paper under clamp, and use the red light line as an
indicator of where the cut will be made (Figure 9).
Figure 9 – Line Light
6.5 Making a Cut
Open the front shield and set the backgauge to the desired position. Place the paper square against
the backgauge and either side guide. Clamp down on the paper using the clamp hand-wheel located
on top of the machine. Close the front shield. Move the red-capped knife latch lever and pull the
cutting lever to the left. Once the cutting lever has moved slightly, the knife latch lever may be
released. Two hands may then be used to complete the cut. Firmly seat the knife into the plastic
cutting stick to assure all sheets are completely cut. If all sheets are not completely cut see 6.6
Adjusting the Knife Depth to adjust the cutting depth. Move the cutting lever to its original position
and raise the hood. The hood will not open unless cutting lever is at its right-most position.
Raise the clamp by turning the hand-wheel and remove the cut pieces of paper.