MyBinding Challenge Spartan 150M, Инструкция по эксплуатации

Страница: 10 / 22

5.0 Installation & Setup
9
5.0 Installation & Setup
5.1 Inspecting Shipment
This machine has been carefully packed to prevent damage during shipment. However, claims for
damage or loss are the responsibility of the recipient. Inspect all shipments as soon as they are
received. If there is any noticeable damage, note it on the freight bill. Visual and/or hidden damage
must be reported to the claims department of the carrier within 15 days. Contact your dealer if you
need any assistance. Check the contents of the box against the packing list on page 7. Make sure
there are no missing items.
5.2 Uncrating
The Spartan 150 weighs approximately 80 lbs (36 kg). DO NOT risk personal injury or damage by
attempting to move machinery with makeshift equipment or inadequate help. This machine is
shipped on a wooden skid and enclosed in a protective, wooden frame and corrugated carton.
Remove the carton by removing the nails or staples holding it to the wooden frame and lift it straight
up over the cutter. Remove the wooden uprights and cut the plastic straps. Carefully lift machine off
skid and set on to work surface or optional stand (see section 5.5 Mounting to Optional Stand).
Screw the lever handle onto the cutting lever.
5.3 Cleaning
After unpacking, wipe down all machine panels and surfaces with a clean cloth.
5.4 Power Hook-Up
SHOCK HAZARD! Possible shock could cause personal injury or death.
Connect A/C adapter to any standard 120 Volt outlet. Have a qualified electrician install one if your
location is not so equipped. The socket-outlet shall be installed near the machine’s location and be
easily accessible.
Figure 2 – A/C Adapter
5.5 Mounting to Optional Stand
Place the machine on the stand. No portion of the machine base should overhang the top shelf of the
stand. If it does, rotate the machine 90
o
and place it back on the stand. Line up two holes in the top
shelf of the stand with two holes on the underside of the machine base. Fasten the machine to the
stand using two 1/4 –20 screws provided with the stand. These screws are used to prevent the
machine from tipping over while cutting.