◈
Contents
Instruction Manual
◈
Installation
◈
Features
◈
Technical Specifications
Image Sensor
Scanning System
Resolution
S/N ratio
Minimum Illumination
Power supply
Power Consumption
Operating Temperature
Field of View angle
Dimension
Weight
1/3” Color SONY SUPER HAD II CCD
PAL 470,000 pixels
520 TV Lines
Minimum 44dB (at AGC off)
0 lux (IR LED’s on)
DC 9 ~ 28V
DC 12V, 375mA (Heater on)
DC 12V, 145mA (Heater off)
-
40˚C to +80˚C
130˚ (Diagonal), 96.2˚ (Horizontal), 69˚ (Vertical)
102(W) x 43(H) x 63(D) mm
326g (total weight incl. bracket & sunvisor: 464g)
* Design And Specifications Are Subject To Change Without Notice.
Best picture quality (in combination with Digital LCD monitor)
High resolution CCD camera (470,000 pixels)
1/3” Color CCD high resolution image sensor
IP69K Waterproof Rating
Diagonal 130˚ Viewing
Normal/Mirror Image switching
Ultra low light performance
Automatic Electronic Iris
Built-in Microphone
Built-
in IR LED’s
Built-
in Automatic Heater (below +10˚C)
Temp. -
40˚C ~ 80˚C
Vibration resistant
Waterproof screw type connector (IP67), 4-pin mini-DIN.
E-mark.
1. Fix the supplied mounting bracket to
the vehicle.
2. Fix the bracket with camera and
sun-shield according to drawing.
3. Adjust the viewing angle of the camera
and fasten the screws firmly.
Caution !!
Camera Assembly
Securing cable connection
Wiring to Monitor
1.
Match the arrow marks and
press the connectors together.
2. Screw the camera connector
up clockwise.
Heater function
(DC 12V)
Audio out
Video out
Power (9~28V DC)
GROUND
Camera pin configuration
Note!
The warranty will not be valid if the problem is related to moist / corrosion in the connector.
Front View
Rear View
Bracket x 1
Instruction manual x 1
Camera Screw Kit x 1
Camera x 1
Sun-shield x 1
Screw cap cover x 4
Monitor
Built-in Microphone
Built-
in IR LED’s
Run the cable from the camera to the
monitor.
CDS sensor
(Photo TR)
①
②
②
②
MXN81C
Extension cable
(Not supplied)
3. Tighten cable connection firmly
in order to prevent water ingress.
AUTO HEATED, INFRA RED COLOR CAMERA
MXN81C
1. Before making the connection, disconnect the ground terminal from the battery
to avoid short circuits.
2. The plugs should be fully inserted into the connectors or jacks.
A loose connection may cause malfunctioning of the unit.
3. A damaged cable may affect the operation of the camera and may even cause
a malfunction of the camera or monitor: Avoid a damaged cable!
4. Protect the cable by using a guide tube, pipe or run the cable inside the vehicle
as much as possible. Caution! Run the cable in natural shapes in order to
prevent cable breaks.
5. Preferably use an acid free grease in between the waterproof screw type
connectors and tighten them firmly eachother.
