◈
Features
1/3” Color CCD high quality image sensor
8
Φ
Urethane cable with waterproof connector
(oil, fuel-&heat resistant)
IP-69K Waterproof Rating
Diagonal 130˚ Viewing
Normal/Mirror Image
Built-in Microphone
Multi purpose
(Frontview, sideview, rearview, surveilance, etc)
Built-
in Automatic Heater (below +10˚C)
Anti-corrosive 3-fold coating
Temp. -
40˚C ~ 80˚C
Vibration resistant
Extra-thick Tempered Glass (2.7t)
1. Assemble the bracket with camera according following drawing:
2. Attach the supplied mounting bracket to the vehicle, adjust the
viewing angle of the camera and fasten the screws firmly.
3. Run the cable from the camera to the monitor.
4. When the picture needs to be changed from NORMAL into MIRROR
then push the NOR/MIRROR switcher on the back of the housing with a
dull pin.
Image Sensor
Effective Pixels
Scanning System
Scanning Frequency
Synchronization
Resolution
Required illumination
Signal to noise ratio
Power supply
Power consumption
Operating temp.
Weight
Dimensions Ball
Dimensions Bracket
Supplied Acc’y
1/3” Color Sony Super HAD II CCD
470,000 pixels
625 Lines 2:1 Interlace
15.625KHz, 50Hz(V)
Internal
520TV lines
0 Lux
Minimum 44dB (at AGC off)
DC 12V +/_10%
DC12V, 110mA Max
-40ºC to +80ºC
Approx. 215g
Ø52mm
73mm x 64mm
M6 x 25mm Stainless machine screw (2)
M3 x 12mm Stainless machine screw (2)
M5 x 16mm Stainless tapping screw (2)
Nylon Nut (2)
Camera Bracket (1)
Rubber O-Ring (2)
Allen wrench 3mm (1)
Caution !!
1. Before making the connection,
disconnect the ground terminal from the
battery to avoid short circuits.
2. A damaged cable can cause defects to
the camera; avoid this! Run the cable in
natural directions.
3. Use acid-free vaseline/grease between
the connectors & screws before fixation
for a guaranteed long lifetime.
Align the marks and
press the connectors together.
Screw the "A’’ up clockwise
in order to prevent water
from infiltrating.
Monitor
to camera input
(4pin Connector)
Camera cable
Connecting Cable
(water Resistant)
Instruction Manual
Autoheated, Heavy Duty Camera
MODEL : MXN22CHD
◈
Camera Input Connector Pin Description
◈
Camera Installation
◈
Connection
◈
Specifications
Back view
