Demon Dribbler
Please retain this leaflet for reference to the
manufacturer.
Made in China to European Safety Standard.
CUSTOMER HELPLINE
We make every effort to ensure that this product
reaches you in satisfactory condition.
However if you have any queries, need
assistance, or find this product defective,
please call our Customer Helpline:
0870 8404255
(UK ONLY)
MV SPORTS & LEISURE LTD
35 Tameside Drive • Castle Bromwich
Birmingham • B35 7AG • UK
Email: [email protected]
www.mvsports.com
DISTRIBUTED BY
Product No. M06032
PLEASE READ BEFORE ASSEMBLY - TO BE ASSEMBLED BY AN ADULT
05.03 - ISSUE 1
CONTENTS:
WARNINGS
Not suitable for children under 36 months
due to long straps which may represent an
entanglement hazard and small parts.
BATTERY CARE INFORMATION
The batteries must be installed / replaced
by an adult only.
Rechargeable batteries are to be removed
from the product before being charged.
Rechargeable batteries are only to be
charged under adult supervision.
Different types of batteries or new and
used batteries are not to be mixed.
Only batteries of the same or equivalent
type as recommended are to be used.
Batteries are to be inserted with the
correct polarity.
Exhausted batteries are to be removed
from the unit.
The supply terminals are not to be short-
circuited.
Do not attempt to recharge non-
rechargeable batteries.
PRODUCT CARE INFORMATION
Do not leave this product outside.
Do not allow this product to get wet.
ASSEMBLING THE START GATE
NOTE:
The 2 holding rings need to slide onto the tube
before fitting the tube into the connector – the rug on the ring
must slot into the corresponding hole in the tube, the ring
must then be pressed together to close. The circular panel
may now be hooked onto the tube between the two rings.
NOTE:
Rotate the
holes in the tube
until they are at the
top or until the gate
functions correctly.
NOTE:
Rotate the holes in the tube until they are
at the top or until the gate functions correctly.
ASSEMBLING THE GOAL (STOP)
NOTE:
The 2 holding rings need to slide onto the tube before fitting the tube
into the connector – the rug on the ring must slot into the corresponding hole in
the tube, the ring must then be pressed together to close. The circular panel
may now be hooked onto the tube between the two rings.
NOTE: The net needs to be threaded onto the each tube before the corner
connectors are fitted.
1
Oval panel
2
Round panel
3
Net
4
Collapsible cones (x6)
5
Flags (x6)
6
Stopwatch
7
Corner connectors (x8)
8
End caps (x4)
9
Holding rings (x4)
10
'T' connectors (x2)
11
Flag labels
12
Pegs (x4)
A
Large tube
B
Large tube with holes
C
Medium tube with holes
D
Medium tube (x6)
E
Small tube (x4)
1
2
3
4
5
6
7
8
9
10
11
12
A
B
A
D
D
D
D
E
E
D
C
D
E
E
B
C
D
E