5.a. Battery recharge fuse
•
The battery recharge fuse is located under the driver’s saddle. To expose it rotate the key and lift the driver’s saddle as shown in the picture.
•
Replace the recharge fuse with the spare fuse.
Some of the possible malfunctions of your motorcycle could be caused by non-integrity of one or more fuses.
The integrity of a fuse can be established by verifying that the corresponding wire (visible in see-through) is not broken or cut off.
In the event of a malfunction, it is advisable to replace anyway the related fuse (see phase 4.) if you have doubts about its integrity.
WARNING: Turn the ignition key on the “OFF” position before checking or replacing the fuses, in order to avoid a short circuit
with subsequent damage to other electric parts of the motorcycle.
WARNING : Never replace a fuse with a rating other than that precribed, in order to avoid damage to the electrical equipment of
the motorcycle which could lead to a fire.
5. Replacing the fuses
F1
F2
F3
F4
F5
F6
F7
Part No. 8A00B3246 - Ed. No. 1
Page 4 of 4
Service fuses list
Ref.
Ampe- Application
rage
F1
15 A
Fuel pump - Coils
F2
7.5 A
Injectors
F3
7.5 A
High beam
F4
7.5 A
Low beam
F5
7.5 A
Starter relay - Turn indicators -
Horn
Service fuses list
Ref.
Ampe- Application
rage
F6
15 A
Tail light- Lambda sen-
sor- Display - Speed sen-
sor - Solenoid secondary
air valve - Position lights
- Power unit
F7
15 A
Electric fans
5.b. Fuses
•
The service fuses are located under the pillion.
•
The spare fuses are contained in the tool bag inside the glove compartment. Replace the damaged fuses by using the tweezers supplied with
the tool bag, with reference to the corresponding functions described in the fuses scheme below.
Spare fuse (40 A)
Battery recharge fuse (40 A)
WARNING: If the warning lights come on or start blinking (see writings in red colour), immediately stop the vehicle, turn off the
engine and contact an MV Agusta Service Centre.
1. Check list - Before starting
It is necessary to carry out the checks described below before each ride.
1. Tyres:
Check inflating pressure (see label on the left side of the steering sleeve)
and the depth of the tyre tread (according to the law provisions of the nation in
which you use your motorcycle).
2. Engine oil:
Check that the level is between the MIN and MAX marks.
3. Brake fluid:
Check that the level is between the MIN and MAX marks.
4. Coolant:
Check that the level is between the MIN mark and the lower side of the
frame tube.
5. Lights, visual and acoustic signals:
Check operation.
6. Fuel:
Check level and refuel if necessary.
7. Registration documents:
Check their presence inside the glove compartment.
2. Starting procedure
WARNING
Only start the engine outdoor, in the open air.
•
Bring the gear lever in neutral position and operate the clutch lever.
• Turn the ignition switch to the ON position.
• Cold starting:
- Rotate the CHOKE lever without turning the throttle
twist grip.
- Press the START button.
- When the engine is warm, disengage the CHOKE lever.
• Hot starting:
- Press the START button.
1
Tyre pressure indicator (red)
2
Turn indicator light (green)
3
High beam warning light (blue)
4
Battery charge indicator (red)
5
Engine oil pressure warning
light (red)
6
Neutral indicator (green)
7
Reserve fuel indicator (amber)
8
“SET” button
9
“OK” button
10
Tachometer
11
Gear display
12
Coolant thermometer
• the display shows just one
blinking segment; it means
that the temperature is low
• all segments are on, while the
upper segment is blinking; it
means that the temperature is
high
13
Rev limiting indicator (red)
14
“HAZARD” button
15
Speedometer
16
“TOTAL” mileage counter
17
Trip counter 1 “TRIP 1”
18
Trip counter 2 “TRIP 2”
19
Clutch lever
20
High beam flasher button
21
Horn button
22
Turn indicator switch
23
Low/high beam button
24
“START” button
25
Engine stop switch
26
Cold start (CHOKE) lever
27
Front brake lever
28
Throttle twist grip
29
Ignition switch
CHOKE lever
START button
Part No. 8A00B3246 - Ed. No. 1
Page 1 of 4
Km covered
1000
6000
12000
18000
24000
30000
36000
(mi covered)
(600)
(3800)
(7500)
(11200)
(14900)
(18600)
(22400)
Service coupon
A
B
C
D
E
F
G
Intervals for scheduled
maintenance operations:
6
7
4
3
2
1
5
1
3. Controls
3
4
5
6
7
8
9
29
2
1
12
11
10
19
28
27
15
21
22
23
25
26
24
Motorcycle model:
Frame No. :
Engine No. :
License plate No. :
Dealer:
Address:
Address:
Phone No. :
MV Agusta
Technical Assistance:
Phone No. :
20
14
13
16
17
18
Dear Customer,
We wish to thank you for your preference and congratulate you on purchasing your new MV Agusta motorcycle.
This manual will provide you with practical informations so as to familiarize yourself with the position and the working of the controls during the first
use of the vehicle.
WARNING: Remember to carefully read the User’s manual and the Maintenance manual before using the motorcycle for
the first time and before having the scheduled maintenance operations performed at the prescribed mileage intervals by
an authorized MV Agusta Service Centre.
2_QM_B5_GB_Ed_1.qxd 15-06-2009 19:22 Pagina 2