_________________________________________________ MuxMeet Share Base-1 Operation Manual
© MuxLab Inc. 2022 Page 90 94-000977-A/SE-000977-A
7.3
U
PGRADING AND
P
AIRING OF
D
ONGLE
:
1.
Plug the dongle to either of the two USB port of MuxMeet Share Base-1 to be updated. A message will automatically show
up to indicate if the installed firmware of the Dongle is older and needs to be upgraded.
Note:
Type C Dongle needs to be plugged into the Type-C port on the front of the Base unit to upgrade.
The upgrading progress starts automatically with the progress bar, as shown below.
2.
“
Pairing”
to the Base unit is done automatically afterwards, it shows as below
3.
Press Exit and unplug the Dongle once the progress bar reaches 100%. The upgrading progress is finished for this unit.
Update all other Dongles accordingly.
