MuxLab 500424, Руководство по установке и эксплуатации

Страница: 4 / 20

HDMI/HDBT 1x4 Splitter Installation & Operation Manual
© MuxLab Inc. 2016 4
Introduction 1.
1.1. Introduction to the HDMI/HDBT 1x4 Splitter
The HDMI/HDBT 1x4 Splitter is an HDBT Splitter accepting 1 HDMI input and
distributing to 4 HDBT outputs, plus 1 HDMI local output which can be used to monitor
local devices or to cascade with additional splitters.
The HDMI/HDBT 1x4 Splitter allows uncompressed 4K/30Hz (max) HDMI, IR, and
RS232 signals to be transmitted over a single CAT5e/6 cable. It supports the
transmission of a 4K signal up to 131ft (40m) and a 1080p signal up to 230ft (70m). If
required, use the HDMI local output to cascade the HDMI signal up to 4 times with
additional HDMI/HDBT 1x4 Splitters. The HDMI/HDBT 1x4 Splitter is also capable of
bi-directional IR transmission and EDID management.
The HDBT Receiver 500454-RX is recommended to utilize the full functionality of the
HDBT outputs of this device.
1.2. Features

Compliant with HDMI 1.4 & 3D.

Transmit 4K @ 30Hz up to 131ft (40m), and 1080p @ 60Hz up to 230ft (70m).

Supports cascading via HDMI Out, IR Cascade and RS232 Cascade.

Supports bi-directional IR and RS232 control and cascade control of 500424.

Supports bi-directional IR and RS232 control of end devices (i.e. source and
display devices).

Real-time display of working status via LED indicators.

Supports EDID configuration, 5 types in total.

Convection cooling, no fan needed.

Antistatic case design: providing good protection for long-term and stable
performance.
1.3. Package Content

One (1) HDMI/HDBT 1x4 Splitter

Two (2) Mounting Brackets

Eight (8) Screws

One (1) 3.5mm male to male audio cable

One (1) RS232 Cable (3-pin Terminal Block to DB9)

One (1) RS232 Cable (3-pin Terminal Block type)

One (1) 24VDC, 2.5A Power Adapter