Media-related troubleshooting 153
"After loading the media..." P. 29
,
, “Ensuring a suitable place for installation” of the “Startup Guide”
Media-related troubleshooting
Is holddown pressure adequate for the roll media?
- Use the slide lock lever on the individual pressure rollers to reduce or cancel the
pressure.
Is the media loaded correctly?
‐ Load the media correctly.
Are any curls or warps present on your media?
‐ Set the edge holder at both edges of the media.
‐ Check that you select the appropriate vacuum fan setting.
Are you using creased, damaged, torn or curled media?
‐ Replace the media.
Is the media loaded correctly?
‐ Load the media correctly.
Is the media loaded at an angle?
‐ Load the media straight.
Did you load the media which has been printed before?
‐ Use a new media.
The printer does not detect
the media.
Do you use the printer within recommended environmental conditions?
- Make sure to use the printer within the specification range.
Are there any foreign materials such as torn paper attached to Pressure
rollers?
- Clean Pressure rollers.
Do you use the printer within recommended environmental conditions?
- Make sure to use the printer within the specification range.
Note
If the media is jammed or torn, remove it according to
Содержание XPJ-1641SR
Страница 8: ...8 ...
Страница 52: ...52 Menus you can access while printing Note ...
Страница 160: ...160 The media is jammed Note ...
Страница 166: ...XPJ16xxSRE A 01 ...