MUTOH XPJ-661UF, Руководство по эксплуатации

Страница: 21 / 174

Precautions when using this product 21
Use the printer with its power turned permanently on. When you are not using the printer, always leave the power on and put
the printer into the sleep mode. In the sleep mode, the printer will periodically circulate the ink inside the printer and carry out
head cleaning automatically. If you do not put the printer into the sleep mode, the ink inside the printer could settle out and/or
coagulate, causing poor image quality or printer failure.
• Before using an ink cartridge, make sure to read the Safety Data Sheet (SDS).
• Do not disassemble Ink cartridge.
Ink may come into contact with your eyes or skin, causing irritation or allergic reaction.
• Wear gloves, goggles or protective eyewear, protective mask, protective clothing when handling ink cartridges.
• DO NOT drop or hit an ink cartridge.
Ink may leak from the cartridge.
• Be sure to use the ink before it expires.
The expired ink should be disposed of as industrial waste. The empty ink bag should be put in a plastic bag and should be
disposed of according to the local regulations.
• MUTOH strongly recommends to use genuine ink.
This printer is designed to bring out the best performance when using with the MUTOH genuine ink.
Non-MUTOH ink may cause print defects or damage to the printer.
• The curing time for Mutoh UV ink varies by surface properties of media you use. Particularly a low ink density area on a print
takes longer time to be cured (approximately one hour).
When you check if your print is fully cured, be sure to wear protective gloves.
• When using this product, wear personal protective equipment (supplied gloves or solvent-resistant gloves, goggles or
protective eyewear, protective mask, protective clothing) to avoid skin contact with ink.
• Especially during operations where ink might contact you (e.g. handling ink cartridges or waste fluid, cleaning of print
head/cap/wiper), always wear personal protective equipment (supplied gloves or solvent-resistant gloves, goggles or
protective eyewear, protective mask, protective clothing) to avoid skin contact with ink.
• If glove becomes contaminated with ink, replace it with new.
• If ink gets on skin, immediately wash with soap and plenty of water for 15 minutes. Seek medical advice/attention if
irritation or inflammation are present.
• If ink gets in eyes, flush eyes with plenty of water for 15 minutes and seek medical advice/attention immediately.
• If swallowed, rinse mouth immediately and do not induce vomiting. Seek medical advice/attention.
Precautions when using this product
Do not turn the power off
Please handle ink cartridge carefully
Avoid direct contact with uncured ink