MUTOH ValueCut VC-1300, Руководство по обслуживанию

Страница: 56 / 63

MAINTENANCE MANUAL
VCE-MM-02
56

The driver board set is damaged. (Change it.)

The linear bearing shaft of VCM is rusty. (Change the Carriage set.)

The two small bearings clamp the linear bearing shaft too tight. (Adjust them).
There are some unexpected lines on the final plot.
[Causation and recovery:]

The blade holder is not installed properly. (Re-install it; please refer to user’s guide.)

The media is not flat enough. Maybe there are some bubbles on the surface. (Re-load the media)

The fan cannot make enough airflow to suck the media. (Change the fan or driver board)

The carriage does not perform the up action. (Please refer to the previous paragraph)

The command of output file of cutting software package is not compatible with HPGL or HPGL/2.
(Ask your cutting software package agent for help.)

There are some communication errors. (Check the communication protocol.)
There appears an unexpected tool force.
[Causation and recovery:]

The setting of tool force is wrong. (Reset the tool force.)

The blade length out of the blade holder is too short. (Re-load the blade.)

The initial force setting is wrong. (Reset the initial force. please contacts the manufacturer.)

VCM is damaged. (Change the carriage set.)

VCM encoder is damaged. (Change the carriage set.)
Media drops sometimes.
[Causation and to recovery:]

Media is loaded askew. (Re-load the media.)

The position of pinch roller is not on the top of drum. (Move the pinch roller to a right position.)
The edge of media is broken. (Change the media.)

The front of media is not even. (Cut the front edge of the media evenly and reload the media.)

Drum is coated with paper chips or dust. (Clean the surface of drum.) Drum or pinch roller is
worn. (Change the drum set or pinch roller.)