MUTOH ValueCut VC-1300, Руководство по обслуживанию

Страница: 54 / 63

MAINTENANCE MANUAL
VCE-MM-02
54

Pre-run the media back and forth using the arrow key will help. (Reload the media and pre-run.)
The edge of the media is not straight. (Change the media.)

Media is too thin. (Change it.)

Drum is coated with paper chips or dust. (Clean the surface of drum.)

Drum or pinch roller is worn. (Change the drum set or pinch roller.)
The lines quality is wavy.
[Causation and recovery:]

Forget to fasten the tool fastening screw. (Fasten it.)

The blade is worn. (Change it.)

The acceleration is too high. (Set the acceleration to a lower value; please refer to the default
value.)

The carriage belt tension is incorrect. (Adjust the belt tension.)

X or Y motor belt tension is incorrect. (Adjust the belt tension.)

The spring loading bearing of carriage is damaged. (Change the carriage set.)

The length of the media is too short in X direction. (Change the media.)

Media is too thin. (Change it.)

Drum or pinch roller is worn. (Change the drum set or pinch roller.)

X or Y motor is damaged. (Change it.)
Data loses when plotting.
[Causation and recovery:]

Memory chip is bad. (Change it.) Main board set is bad. (Change it.)
Fatal error occurs when loading media.
[Causation and recovery:]

Forget to pull out some media from the media roll. (Pull out some media from the roll before you
start to load media.)

X motor belt is too tight. (Adjust the belt tension.)
Feel electrostatic discharge.
[Causation and recovery:]

Power out let does not have ground connection. (Improve it.)