FlexiSTARTER Quick Start Guide
ValueCut USER MANUAL
96
VC2E-A-00
8.9.5 Create a cut contour mark
In the aftermath of "8.9.3. Create data of the contour cut line" on the previous page, this is how to create
a contour cut mark.
1.
Select "Contour Cut Mark" from the
Effects menu.
“If "Contour Cut Mark" is not active
from the Effects menu, select the
contour.
2.
The contour cut mark may be created.
Assign a kind of the mark from the
Design Central window. This time, Mutoh
4 Point Positioning is applied.
3.
Set up in the Design Central window as follows:
a.
Select "Mutoh 4 Point Positioning".
b.
Set up length from the object to the mark. Generally,
leave "0".
c.
Set up copies horizontal direction. "1"
d.
Set up copies vertical direction. "1"
e.
Set up a interval of the copies. It’s not necessary for this
time.
f.
Select the contour cut mark size. (10mm - 25mm)
g.
Click on
to confirm the cut contour mark.
1
2
a
b
c
d
e
f
g
3
Содержание ValueCut II Series
Страница 60: ...Automatic Aligning System ValueCut USER MANUAL 60 VC2E A 00 Figure 5 1 Figure 5 2...
Страница 111: ......
Страница 112: ......
