MUTOH Kona 1400, Руководство пользователя, Страница: 138 / 218

User’s Guide Kona / Kona apparel cutting plotter
Operation panel
138 AP-75370 - Revision 1.1
EPOS read
To be able to perform a contour job, the EPOS sensor needs to see the difference between
the media and the printed bounding box. When loading a media and the measurement of the
bounding box fails, it is interesting to perform the EPOS read test. Via this you can see if the
sensor is able to detect a contrast between the media and bounding box.
Perform the test as follows:
Step 1:
Press the following buttons in order:

Actions

next page

EPOS read
Step 2:
The EPOS sensor is activated.
Step 3:
Move the media away under the sensor and check if the read value changes from
white (media) to colour (bounding box).

White is approximately 1000

Black is < 400
Step 4:
If this is not the case, it is impossible to use the automatic alignment method and
you should switch to the manual alignment mode.
Refer to
Contour cut on page 124