> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
88
\
B E D I E N E L E M E N T E
B E D I E N E L E M E N T E
B E D I E N E L E M E N T E
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
Manual SDs-01 D 3.2.2003 17:45 Uhr Seite 3
CONTROL ELEMENTS
MC-2 Front Panel
1 POWER
This red LED lights up when the unit is switched on with the rear panel
POWER switch.
2 SELECT
The toggle switch selects one of the two functional areas available.
3 DATA
Use this toggle switch to select a function from a specific functional area.
4 STATUS
This area indicates the status of the internal low-jitter PLL.
5 MODE
This area enables the selection of the reference input as well as the needed
conversion mode.
6 AES/EBU ID
OUT
This function enables to select two different output voltages for the
AES/EBU ID outputs.
7 CLOCK
IN
This status area indicates the clock rate of the current incoming reference
signal.
8 AES/EBU OUT 5 + 6
These are AES/EBU signal distribution outputs no. 5 + 6.
MC-2 Rear Panel
1 AES/EBU ID OUT 1 + 2
These outputs transmit digital AES/EBU ID blank frame reference or audio
signals in accordance with the specifications of the standards
AES 3 ID – 1995/2001. The output impedance is 75
Ω
(BNC connector,
female).
2 AES/EBU OUT 1 – 4
These outputs transmit balanced digital AES/EBU blank frame reference or
audio signals in accordance with the specifications of the standards
AES 3 – 1992/2003 and AES 11 – 1997/2003. The output impedance is 110
Ω
(XLR connectors, male).
3 AES/EBU IN
This input receives balanced digital AES/EBU blank frame reference or audio
signals in accordance with the specifications of the standards
Refer to the OPERATIONS chapter for more
information.
9
MC-2 Rear Panel
MC-2 Front Panel
5
3
2
1
1
2
3
4
5
8
4
6
7
