1. Do not attempt to modify the unit, modifying the unit may cause an accident.
2. Installation or servicing of the unit by persons without training and experience
in electronic equipment and automotive accessories may be dangerous and
could expose you to the risk of electric shock or other hazards.
3. Stop the vehicle before carrying out any operation that could interfere with
your driving.
4. Keep the volume at a level which you could hear sounds from outside the
vehicle.
5. Do not work in extremely high or low temperature. Be sure the temperature
inside the vehicle is b60°C and -10°C before turning on your unit.
6. When replacing the fuse(s), the replacement must be of the same amperage
as shown on the fuse holder.
7. Do not block vents or radiator panels. Blocking them will cause heat to build up
inside and may result in fire.
8. Using this unit without running the engine can result in battery drainage.
9. Use only in cars with a 12 volt negative ground.
10. After completing the installation or replacing the car battery you need to
RESET the unit before using it. Remove the front panel and press
RESET
button
on the base with pointed object (such as ball-point pen) to reset the unit to its
initial settings.
M-090 MR
GB - 1
User Manual
CAR RADIO WITH USB & SD
Please read the instruction carefully
before operating the unit.
PRECAUTIONS
English
GB - 2
GB - 3
CONNECTION
Caution!
- Make sure to connect the color coded leads according to the diagram. Incorrect
connections may cause the unit to malfunction or damage the vehicle’s electrical
system.
- Make sure to connect the speaker (-) leads to the speaker (-) terminal. Never
connect the left and right channel speaker cables each other or to the vehicle body.
- Make sure all the connections are completely correct before turning on your unit.
- Before wiring, disconnect the cable from the negative battery terminal.
Do not connect the ignition wire (red) and the battery wire (yellow), it may
cause a short circuit, even result in fire.
GB - 4
GB - 5
GB - 6
UNPACK YOUR UNIT
When you unpack your new car radio, make sure that you have removed all the
accessories and information papers:
Main unit
User manual
Accessories:
Install the unit
- Method 1: DIN Front - Mount
INSTALL AND REMOVE THE UNIT
GB - 7
1
7
4
2
5
3
6
M
O
D
E
BAND
AUX IN
DIR-/8
RESET
SD/MMC
AS/PS
/R
DIR+/9
DM
PTY/0
SEL/VOL/AF/TA
Reset
5.5
1. Insert the mounting sleeve to the car. Bend the claws outward for a tight fit, if
necessary.
M5 x 25 Screw
2. Combine mounting blot, steel bar, spring washer and Hex nut. Then combine
the unit and dashboard with M5x 25 screw and plain washer.
- Method 2 DIN Rear-mount (For Japanese car)
1. Select a position where the screw holes of the mounting bracket supplied with
the car and the screw holes of the main unit become aligned (are fitted).
M5X5.5 Screw
M5X5.5 Screw
2. Tighten the screws. And then fasten them to the car.
Detach the Unit
Insert the keys supplied on the both sides of the unit (shown as illustrated)
until they click. Pulling the keys and makes them to remove the unit from the
dashboard.
LOCATION OF CONTROLS
1
7
4
2
5
3
6
M
O
D
E
BAND
AUX IN
DIR-/8
RESET
SD/MMC
AS/PS
/R
DIR+/9
DM
PTY/0
SEL/VOL/AF/TA
1 2
3
4 5
6
7
17
16 15 14 13 12
11 10 18
9
8
1.
7/MODE
button
2.
0/BAND/PTY
button
3.
1
numeric button
4.
8/ /DIR-
button (Skip backward /Directory down)
5.
/SEL/VOL/ AF/TA
knob (Power/ Select setting/Volume)
6.
4
numeric button
7. LCD display
8. AUX IN jack
9. USB port
10.
6
numeric button
11.
5
numeric button
12.
9/ /DIR+
button (Skip forward /Directory up)
13.
2
numeric button
14.
3
numeric button
15.
AS/PS
button
16. /
RDM
button (Play/ Pause/Random)
17. SD/MMC card slot
18.
RESET
button
BASIC OPERATIONS
Turn on/off the unit
Press button (5) to turn on the unit. Press and hold this button again to turn off
the unit.
To display and adjust the current time
In standby mode, the current time will be displayed automatically.
Turn on the unit, press and hold
MODE
button (1) until clock time appears. Long
press
MODE
button (1) again ,the hour digits will flash, set the HR. hour with
/
button (4/12).Then shortly press
MODE
button (1), the minute digits will flash,
set the MIN. minutes with /
button (4/12).
Note:
It will return to normal display mode if no key is pressed within 5 seconds.
Mode selection
Repeatedly press
MODE
(1) button to select different sourcing mode: Radio→
USB →SD/MMC →AUX.
Reset the unit
Operating the unit for the first time or after replacing the car battery, you must
reset the unit. To set the unit to initial status, press
RESET
button (18) with a
pointed object. When some errors occur in display, you can also reset the unit,
but it will erase the clock setting and some memorized functions.
SOUND FEATURES
Volume:
To increase or decrease the sound level, rotate
SEL/VOL
knob (5) clockwise or
counter-clockwise.
Sound Settings
Repeatedly press
SEL/ VOL
knob (5) to select the desired mode in the following
order: “BAS” (Bass) -> “TRE” (Treble) -> “BAL” (Balance) -> “FAD“ (Fader) ->”
LOUD”(LOUD ON/OFF) -> “LOC”(LOC ON/OFF) -> “AF” (Alternative frequency)
-> “TA” (Traffic announcement) -> “REG” (REG ON/OFF) ->”EON” (EON ON/
OFF) -> “VOL” (Volume). After selecting the desired mode, you can adjust the
current level by rotating
SEL/ VOL
knob (5).
Note:
- The unit will return to the previous mode if no adjusting happens within 5
seconds.
- Refer to radio section for LOC, AF, TA ,REG and EON.
Switching Loudness On/off
Repeatedly press
SEL/VOL
knob (5) until “LOUD” shows on display, rotate
SEL/VOL
knob (5) to select “LOUD ON” mode to activate LOUDNESS function.
By this function, you can increase the low frequency, which can improve sound
sensitivity. Repeatedly press this button again ,then rotate
SEL/VOL
knob (5) to
select “LOUD OFF” mode to cancel LOUDNESS function.
CONNECTOR A
1.
2.
3.
4. +12V CONSTANT POWER SUPPLY
5. POWER ANTENNA / AMPLIFIER TURN ON
6.
7. +12V ACCESSORY/SWITCH
8. GROUND
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
FIXED ISO FEMALE CONNECTOR
ANTENNA
SOCKET
RCA AUDIO OUT
R (RED)
FUSE
HOLDER
L (WHITE)
WIRING DIAGRAM
AR-3453 IB MUSE 001 REV0 GB.indd1 1
2013-5-3 9:15:13
