Specification
INPUT:
Audio
XLR-3, Hi Z balanced, 100K leg/leg
0dBV.7 nominal
Looping
D25-M/D25-F (all Group), XLR3s Gp1 &2 only.
CMRR
40 dB minimum, nominal
max >6v CM signal
Switching
4 Balanced stereo pairs, electronic switching.
OUTPUT
PPM
Reduced 40 x 20mm scale dimension, to BS6840
Sifam manufactured, LED illumination
Freq resp
-1dB nominal, @ 10Hz & >25KHz
Ballistic
100mS (10KHz @ +8dB) peaks "6"
5mS ( .. ) peaks "5"
Peak Ind
Red LED illum8dB + 0.15dB achievable
Phase
Green/Red LED for correct/error respectively
Presence
Phase LED extinguished below approximately -25dB
Audio loudspeaker
>2 Watts/channel (electrical power)200Hz - >16KHz
Headphone
Current limited OP on
1
/
4
” Jack, mutes LSA
POWER
ac
100 - 250v ac 10 VA nominal
fuse
3.15A T, delay
Case
482W x 44H x 175D excluding connectors <3Kg
Humidity
non-condensing, Protection: IP50
Note: the figures in this specification are typical, and given for guidance only.
MURRAYPRO
Mini-Mon3
Program Meter
conforms with the following EC Directive:-
89/336/EEC for EMC
73/23/EEC for LVD
EN550081-1
Part 1
Emissions,
EN550082-1
Part 1
Immunity,
EN60950 1992
Electrical Safety Sept 2008
Murraypro
Mini-Mon3 MANUAL
(AES option
NOT FITTED
)
Designed and manufactured in the UK by Murraypro Electronics
Tel: (+44) 020 8943 1920
MiniMan3-2.lwp
Serial No:-......................................
The
MURRAYPRO MINI-MON3
provides high quality, full-function,
stereo monitoring facilities in a compact unit only 1U high.
Designed for space limited, near-field audio monitoring applications, the
self-contained
MINI-MON
provides stereo loudspeakers, current limited
Headphone amplifier, Peak Programme Meters, Peak overload LEDs, stereo phase
verification and audio presence confirmation, together with touch-latch selection
between 4 analogue Stereo Groups.
True PPM scaling together with the classic fast attack and slow decay
times are ensured by the high specification precision meter drive amplifier. The
miniature movements that are fitted in this 1 U height unit have a slightly relaxed
specification, but very closely emulate the full-sized BS 6840 meters. Internal, white
LED illumination is provided to ensure full visibility of the meters under all
operational conditions.
PEAK LEVEL INDICATOR
Independent ultra-bright red LEDs indicate peak input signal levels in
excess of +8.15dBU (+0.15dB) for each channel. These LEDs conform with the full
PPM specification, and are not subject to the ballistic considerations of meter
movements.
For Loudness monitoring, to confirm conformance with ITU-R BS.1770-1,
the Peak threshold may be reduced from +8.15 to +2.15dB, if desired.
