Operation Manual MK200
4
2. Installation
Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer
is not responsible if an incorrect installation and use causes injuries and damages. Always keep the
instructions with the appliance for future reference.
WARNING!
Flammable material. This appliance contains R290/Propane a flammable refrigerant.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
The appliance shall not be stored in a room with continously operating ignition sources (for example;
open flames, an operating gas appliance or an operation electric heater). Do not pierce or burn.
Be aware that refrigerants may not contain an odour.
Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only
use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
If the supply cord is damaged, it must be replaced by the manufacturer, Munters Service or similarly
qualified persons in order to avoid a hazard.
CAUTION!
Only a qualified person must install this appliance. Remove all the packaging. Do not install or use a damaged
appliance.
The appliance shall be installed, operated and stored in a room with a floor area larger than 4m². Obey the
installation instruction supplied with the appliance.
Always be careful when you move the appliance because it is heavy. Always wear safety gloves.
Make sure the air can circulate around the appliance.
Wait at least 4 hours before connecting the appliance to the power supply. This is to allow the oil to flow
back in the compressor. Do not install the appliance close to radiators or other heat sources. Do not
install the appliance where there is direct sunlight.
2.1 Electrical connection
WARNING!
Risk of fire and electrical shock. The appliance must be connected to a grounded outlet.
Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact
an electrician.
Always use a correctly installed shockproof socket and make sure that the power supply is sufficiently
fused. Do not use multi-plug adapters and extension cables.
Make sure not to cause damage to the electrical components (e.g. mains plug, mains cable).
Contact the Munters Service or an electrician to change the electrical components.
The mains cable must stay below the level of the mains plug. Connect the mains plug to the mains socket
only at the end of the installation. Make sure that there is access to the mains plug after the installation.
Do not pull the mains cable to disconnect the appliance. Always pull at the mains plug.
